ร้านซ่อมเครื่องวัดความดัน is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the free rock mass. The maximum grain size cannot exceed zero.2 mm.
Grouting pump operation and maintenance is simple, protected and dependable. This pump is used in mines working under difficult circumstances because it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base body and stand, strain gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it works
Pneumatic stress within the air cylinder exerts a high stress on the grout mixture which ends up in ejection of grout with a excessive pressure and velocity. The valves of the air cylinder in the pump perform mechanically to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to complete the pumping cycle.
Pneumatic grout pump may be pushed even without Electrical power provide in remote areas by using engine driven compressor.
Applications
The pump is majorly used in development and mining trade for injecting material into broad and medium dimension gap in beams, columns ,basement walls and flooring, raise shaft concrete wall fill-up and so on. In mining business it’s used to refill cement answer the place there is a gap exists between construction and rock and for soil stabilization.
Detachable design tends to simple maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely utilized in tunnels, coal mine, bridges and dams, building foundation, and different underground projects, and inflammable, explosive sites and different bad environment.
เกจวัดแรงดันปั๊มลมpuma has utility in chemical industry also to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any site situation whether or not it’s rural or urban.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment vary. Generally the final amount of the grouting volume is 8 or10 times of the amount to start with. And the ultimate grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and circulate could be adjusted based on the requirements of grouting,(The flow of grouting pump is 0-100L/min, pressure of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electrical energy, construction, mining and so on. ground/underground construction.
Benefits
Mining Pneumatic Grouting pump has some great advantages of low vitality consumption, small vibration, low noise, small dimension, high effectivity, dependable efficiency, strain and move control, lengthy life and so forth. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can also be Light weight and with a wheelie design it might be carried easily. It is designed for straightforward operation and low maintenance. Last but not least its spare elements are simply out there.
Share